How To Remove Jacuzzi Drain Plug

Place the submersible pump in the footwell of the hot tub at the deepest point. Locate drain valve plug in cabinet panel and remove it.

How To Remove A Bathtub Drain Stopper

I will show you how to remove a pop up bathtub drain plug stopper in under 1 minute with no.

How to remove jacuzzi drain plug. Make sure it is securely tight. Once empty simply turn off the pump and remove it. It is located at the bottom or at the corner of a hot tub.

With the stopper in the open position simply grasp the plug by hand and pull upwards with a wiggling motion to remove it from the drain opening. You should be able to confirm that it is the drain. Wriggle the stopper while pulling it up to remove the entire assembly.

Place a screwdriver between the handles of the pliers and push the screwdriver counterclockwise to loosen the drain and remove it. Put the stopper in the tub and fill it with a small amount of water. Other types of drain plugs will usually have one or more screws that you will have to loosen to remove the plug.

Clean or replace the assembly and screw on the cover and drain plates. The job sounds pretty simple right. Find the main hot tub drain plug.

This is a set of 2 drain plugs and 2 O-Rings that you use to plug the strainer body of your pump. Hose Suction Trick Draining a Hot Tub all the way to the bottom of the footwell Instead of using the built-in gravity drain to empty your Jacuzzi or other spa you could also try this method of draining the hot tub. Is your pop up shower stopper or bathtub drain clogged with hair.

Run the hose from the pump to your drain. The drain plug allows you to prepare for winterizing by easily releasing the water by removing this piece. Remove the knob on the top of the stopper.

Use the main plug to drain most of the water. If the knob will not unscrew then wrap the rag around the knob and use the pliers to help remove the knob. Lay a few pieces of paper on the floor under the pipes where you suspect the water is dripping Have your helper remove the stopper while you shine a flashlight on the drain.

The hardest part sometimes is trying to actually remove the tub drain stopper. Turn the pump on and this will begin the draining process. Fits many different pumps.

Remove front cabinet panel under touch pad by unscrewing and removing the top rail and 1. Start by actually inserting the hose into the filled spa as. Remove Soap Scum or Hair from Drain Use a small scrub brush to remove soap scum or hair inside the drain opening.

2 Remove any old putty or caulk around the drain hole in the. Attach a garden hose. Turn the hot tub power off at the circuit breaker.

If you have an auxiliary plug use it to get rid of water from plumbing. Hold the body of the stopper in place with one hand and with the other hand unscrew the knob by turning it counter-clockwise. For a foot lock or roller ball plug simply rotate it counterclockwise until it separates completely from the drain shaft.

Be careful as it will not be attached to the drain. Check whether your hot tub has an auxiliary plug. The hose should be empty before draining.

In the case of a lift-and-turn drain lift the plug and free it by.

How To Remove A Bathtub Drain Stopper