How To Remove Lawn Mower Blade John Deere

Take out the key and wait for the engine and attachments to completely stop moving before leaving the seat. Engage the parking brake by pressing the parking brake lever located to the right of the steering column.

Pin On Repairing A John Deer Deck

Locate the grease nipple directly underneath the middle of the axle.

How to remove lawn mower blade john deere. Pull out the free-wheeling lever on the rear the mower between the wheels and below the seat. A 1516-inch socket and a 12-inch drive ratchet are needed to remove the bolt that holds the blade in place. To remove the blade you must turn the blades retaining bolt to the left or counterclockwise.

In order to take out the blade turn the mounting nut in the middle of the blade counterclockwise. In this video i show you how to take off your blades Easy without taking the deck offI use my homemade wooden ramps. You do not have to remove the deck to remove and sharpen the blades.

I also have a video on how i built my. Pay attention to the position of the blade as youre removing it. The same idea applies to twin blade tractor mowers.

5 Place the blade. Simple if the blade is designed to cut turning left then it will be a right hand thread this is the most common type. Put the end of the grease gun in the nipple and pump the handle to grease the axle.

Pull the bolt and washer from the bolt and spindle and then remove the blade from the spindle. When parking the machine stop on a level surface and disengage the mower blades. To remove the blade you must turn the blades retaining bolt to the left or counterclockwise.

By jacking up your machine the blade will be exposed. Turn the mowers engine off and remove the key from the ignition. Before undoing the blade tip the mower on.

To loosen a right hand thread you turn it to the left. Step 2 Use a wooden block or a large wrench to keep the blade from spinning. Lower the attachments all the way down set the parking brake and stop the engine.

By doing this youre loosening the blade. Before undoing the blade tip the mower on its side with the engine air cleaner facing up and block the blade with a piece of wood so it cant turn. A left hand thread is common on lawn tractor mowers.

Use a socket wrench of the appropriate size and unbolt the mounting while using your other hand to keep the blade from turning. How to remove the mower deck and replace the blades on a John Deere riding lawn mower with torque specs. Locate the grease nipple on.

I wanted to remove the blades on my John Deere D110 riding mower to sharpen them. Raise the mower deck to the top or most upright position to gain access to the underside of the mower deck. Just take it out once its fully loose.

Be careful not to lose any washers or mounting hardware that hold the blade into place which can be reused. Remove the blade mounting bolt. Removing the mower blades from your John Deere mower requires attention to safety.

Obtain a suitable replacement blade from a mower repair shop or hardware store. Park your mower in an appropriate area with the parking brake applied.

Pin On John Deere X300

Pin On Tractors