How To Remove And Reuse Quarter Round

Slip the blade of a putty knife or painters 5-in-1 tool behind the quarter-round molding. The alternative is to remove the quarter-round and reinstall with caulk after finishing the floors.

How To Remove Quarter Round Trim 8 Steps With Pictures

To aid in re installing the quarter round number each piece in order as you remove it around the room.

How to remove and reuse quarter round. What is gonna happen is that when the hardwood shrinks if you were right up to the edge of the quarter round when you left the gap you will now see a gap. Look for gaps along the top where it meets the baseboards or along the floor. The Shoe moldingquarter round is then added to the baseboard to HIDE the expansion gap.

Based on the additional labor the cost of. The contractor mentioned that they would not be removing the quarter-round below the base board and it would require touch up after the job is done. Break of all the original brads by holding the brad close to the quarter round with long nose pliers and twist back and forth with a rocking motion until the brad breaks.

Go along the quarter round until there is a natural break in the molding such as a corner or mitered edge. Im getting ready to sand and refinish the oak floor in the hallway. Remove Nails From Molding Virginia says.

The baseboards are supposed to hide the expansion gap. The hardest part of removing quarter round is finding a good starting point. Heres a quick video showing how to remove wooden oak quarter round trim.

When done properly there should be no need for shoe or quarter round. 8 thoughts on How To. If youre trying to save your quarter round or trim be.

You can buy a box of short 1 brads at the Hdw store. Using a utility knife score along the top and bottom of your quarter round. Use the long nose pliers to start the brads with a hammer.

Were getting ready to reuse baseboard trim for our new bathroom. For tight areas I used the hammer and lightly tapped the top of the putty knife handle to get it behind the quarter round. Shoequarter round are often used when the baseboards are LEFT in place and the expansion gap is visible.

Take the putty knife and wedge it between the quarter round and the baseboard. Release pressure on the tool move to the right 3 inches and pry outward again. Work the putty knife into those gaps and gently apply pressure against the wall.

Also make sure to undercut the thresholds. Wiggle the putty knife back and forth along this seam until the quarter round pops loose from the wall. Gently move the putty knife back and forth to create a gap between the quarter round and the baseboard.

Do this all around the room. Slip the blade of a putty knife or painters 5-in-1 tool behind the quarter-round molding. Release pressure on the tool move to the right 3 inches and pry outward again.

October 5 2018 at 1015 am. So good to know. Its more work but you will be better off in the end especially if you are installing the floor during warmer and wetter months.

Our contractor is not the best when it comes to being a little extra careful with. Apply a decent amount of pressure to ensure youre really slicing through the caulk lines. The middle is usually a little loose compared to the ends where there are more nails holding it in place.

How To Install Baseboard And Shoe Molding For Hardwood Floors Moldings And Trim Floor Molding Baseboard Styles