How To Remove Vinyl Siding Bottom

70 water 30 white vinegar makes a great all-purpose vinyl siding cleaner that removes light mold and mildew stains. Start by lifting an overlapped piece of vinyl on the top row.

How To Remove Vinyl Siding 11 Steps With Pictures Wikihow

Pull the zip tool downward and out to unhook the bottom lip then slide it along the edge pulling the siding out as you go.

How to remove vinyl siding bottom. Install J channels at doors and windows and under roof eaves and rakes. Hold them out of. Then unzip any pieces above the damaged piece.

Repeat until youre at the ground and then remove the surrounding trim. The vinyl siding zip tool will save you loads of time. Starting at one end of the damaged piece push the end of the zip siding removal tool up under the siding until you feel it hook the bottom lip.

Pull the zip tool downward and out to unhook the bottom lip then slide it along the edge pulling the siding out as you go. For a stronger solution. Slide the zip tool along the bottom edge to release the vinyl siding from the piece below it.

Look for a horizontal seam between two courses of vinyl siding. You should be able to slide it horizontally and remove it from the channel to expose the nails from the second row down. Along the tops install J-channel trim with horizontal siding and base trim with vertical siding.

Use a cats paw or other small pry bar to pull the nails from the course you need to remove. Slide the zip tool along the bottom edge to release the vinyl siding from the piece below it. Pull the piece of vinyl siding downward to disengage it from the course below it.

The nails for the first course will be accessible now. Cut the trim so it is two channel widths longer than the openings width. You will actually start by pulling the bottom of the second course out of the top of the first course.

Then unzip any pieces above the damaged piece. Now you can remove the j. Insert the siding-removal tool where the panels overlap and pull down and out.

To unlock a section of vinyl siding using only a screwdriver find the end joint insert the screwdriver into the bottom locking edge and pry down and out on the edge until you can grab and pull the bottom edge outward and unlock the corner slide the screwdriver. Start cutting with your tin snips at the top interlock and continue toward the bottom of the panel. Remove the nails one at a time to disconnect the entire length of vinyl.

Ask This Old House general contractor Tom Silva helps a homeowner repair sections of his vinyl siding that have holesSUBSCRIBE to This Old House. Remove the nails and the piece of siding. You will need to remove the bottom course of siding with your removal tool.

Removing Vinyl Siding Fine Homebuilding