Can't Remove Toilet Water Supply Valve

Replace a leaky toilet water shut off valve. Clean the washers with a cloth.

Toilet Repairs Part 2 Replacing The Fill Valve Pretty Handy Girl

If youre not sure consider shutting off your main water valve.

Can't remove toilet water supply valve. Disassemble the Shutoff Valve. Wipe down the tank with a micro-fiber cloth to remove and remaining water. When you turn the water back on.

The bidet installation instructions presumably told you to close the valve on the wall so double-check that. Disassemble the shutoff valveleaving the toilet and supply lines intact. Get that valve unstuck without re.

I then would proceed counter clockwise with a second offset 6 pipe wrench and try to loosen. All the toilets have these supposedly chrome supply pipes coming out from the wall and then a bendable probably aluminum pipe going up to the toilet. To be honest before I grabbed the hack saw I would always set up a straight 6 pipe wrench inside the toilet tank and position it at the base of the fill valve with the handle up against the toilet tank.

Flex the neoprene to try to get it supple again. No problem unless you have to turn off one of the valves like when replacing the toilet fill mechanism. DIY for stuck shutoff valve bathroom toilet kitchen brass craft type shut off valve that wont budge then this is for you.

Use the bottom wrench to hold the valve body be careful not to damage the fine threads for the packing nut and use the top wrench to remove the compression nut for the supply line. If the valve moves at all add a little more penetrating oil to it. The valve nut locks the toilet valve body into the toilet tank.

Place an open ended wrench on the valve body and a 58 open ended wrench on the compression nut for the supply line. Dont use any pipe dope or plastic tape on the valve. Good advice above on how to remove the thing.

Avoid gumming up the inside of the shutoff valve. Tap again with the hammer to help the oil work its way into the valve. Try to open the stuck valve now that the oils had a chance to work.

Try gently tapping the water valve with a hammer to help the oil penetrate the valve. Using adjustable pliers or adjustable wrench remove the valve nut. While youre working keep a bucket that would fit under the tank nearby.

Complete installation instruction on how to replace a straight or angle water shut off valveIf the water wont. Two other points just in case. Remove and lift the fill valve from the tank.

How To Fix A Toilet Parts Water Supply Valve Youtube